The above video goes away if you are a member and logged in, so log in now!
Help with a problem –
i recently purchased a non-modified ps1 from an op shop the other day. i wanted to mod it so i could play my backup games so i went to a website called eurasia and bought a mm3 modchip off of them. i got the modchip and tried to solder it on. but i have run into a problem in that the ps1 will now not start at all. the laser and disc will not spin. it appears as if the ps1 is not getting power although the green led is coming on. i have removed the modchip so i dont think it was that and the ps1 did play and start before i tried to install the modchip
thanks in advance for the help
i will do anything you tell me too as i am clueless when it comes to repairing a ps1
i know it's a very stupid question... but have you attached the cables that go from the PSU to the motherboard?
yes i have attached the cable even tried putting it on the other way. the power is definitely going into the power supply but dosent power the motherboard
do you have a multimeter? have you checked if any voltage is coming out of the PSU ? power may be going in but not coming out. checked the fuses?
136 installs , last on 16-NOV-2013
PS2 50002 PAL Silver
+ Network Adaptor + 500 Gig
Hitachi IDE + FMCB 1.8b
PS2 79002 PAL
Slim Unmodded FMCB 1.8b
black CFW 6.60 B10 PhotoFast 5400 with 2 x 8 Gig micro SDHC
Post pictures of the solder install or points, this way we can see if there is a solder bridge.
no theres definitely no solder bridge i had my dad have a look at it
Originally Posted by jinn
will do that tommorow and get back to you
Originally Posted by spud42
Can you tell me the model number [SCPH-####]
Which MM3 version did you order?