DMS4 Lite SE + v14 GH041-04

[drewid]

i just tried a DMS4Lite SE on a v14, and found i was getting BSOD :(

when it did boot i found that a number of times it wouldnt recognise the board properly with it sometimes saying it was a EUR J and othertimes picking it up correctly..

i did update the chip with 0.6 using fastboot, and also tried toxicbios v1.4 and the same thing happened..

seems to be only a v14 issue as i then tried the same chip in a v9 and it worked flawlessly, and i even installed it pretty roughly to see how it would take it..

but if anyone can help me with the v14's i would appreciate it..

[bunghoolio]

Thats strange... I havn't had any probs using DMS4Lite and then flash via MCard 1.4 bios on V14 PAL. If you have "V" connected, you should disconnect it as this is for JAP machines only. Also Make sure that "C" point on DMS go to "Q" point on motherboard. This will help lots.

[drewid]

this is a DMS4Lite SE, the new small PCB Lite.. i didnt connect the V point, but i did connect the C point as per their new diagrams..

[dungbeetle46]

I have just done one of these on the same board and works perfect, suggest triple check wiring