PDA

View Full Version : Alternate v14 mobo- can anyone help??

puargs
11-19-2005, 05:09 PM
I purchased a v14 console the other day and decided to get a crystal chip what with the new compatibility firmware releases, but i open up my console and low and behold- a different motherboard than they have listed on their site! (type GH-040-52)

Does anyone have wiring diagrams for the crystal chip for this?? If no one's seen it, I took a few pictures, you can download them here. PICTURES TAKEN DOWN DUE TO BANDWIDTH HIT. CRYSTAL CHIP IS NOW WORKING ON THIS REVISION. :-pray: thanks for any help you can give me!
guerrierodipace
11-19-2005, 07:58 PM
maybe it is a V15,in Italy we have the new GH-041
puargs
11-19-2005, 08:03 PM
It is SCPH-75001, so that's why I'm a little confused.
spedmetal
11-19-2005, 08:07 PM
That looks much different but its a little hard to tell from the pictures. Please post a better picture of the cdvd point ...... area 4 in this picture here.

http://www.crystal-chips.com/documents/diagrams/cc11/cc11_v14.jpg

@guerrierodipace the CC team has already documented the gh-0041
puargs
11-19-2005, 08:36 PM
PICTURES TAKEN DOWN DUE TO BANDWIDTH HIT. CRYSTAL CHIP IS NOW WORKING ON THIS REVISION.

I retook the pictures, in a circular pattern- 030.jpg is the best picture I can get of the CD / DVD point you asked about.
spedmetal
11-19-2005, 08:45 PM
The new pictures are much better and your right that looks like none of the v14 diagrams out currently.
summ0ne
11-22-2005, 09:23 AM
its a v15 - same thing as a v14, only different layout.

i am making diagrams as we speek
ZootAllures
11-26-2005, 11:53 AM
Yeah I hope those square pads are used for the CD/DVD controller points. It would be alot easyer to solder than scratching away the coating on those through hole pads on the v14. I noticed the coating is alot thicker than the v12-13 pads and takes a little more effort to clean them up so they can be soldered to.