h20 - v3 - pal - black screen .

[EspeN]

No bridges.
Removed chip, same shit.

Anyone know whats up and what to check?
I have very little experience with v3, so im clueless.

BIG THANKS!!!

[summ0ne]

check for shorts on the mechacon

[EspeN]

Oh, i didnt check that coz i thought that wouldnt give me black screen.

Take a look at the R point on H20 diagram. That small resistor got loose, but i replaced it with another one. Can this resistor cause black screen?
Is there no fuses on this mobo to check?

Thanks for mechacon tip, ill check it when i come home from work.

[summ0ne]

yes, the r can also cause black screen

[EspeN]

Solution was the R part.

I prob fried it. I found a old v12 board and found a part that looked equal and installed it in the v3.

Now the console boots normal again!!

Very nice, thank you!