Alternative 3.3V spot for a V13 Slim [Archive]

View Full Version : Alternative 3.3V spot for a V13 Slim

d_guth

10-10-2005, 10:08 PM

Hi guys....my board is a GH-032-53 and noticed that my resistor on the 3.3V spot is marked 202 (usually means an ohms rating for SM stuff) while the install pic V12 diagram is shown as 50 marking.

Just looking to confirm that this same spot on a V13 is indeed 3.3V like the V12 board despite the resistor marking difference before I begin.

N£TM£ÇH

10-11-2005, 10:53 PM

it is.. 50 ma would have 3 volts going through it.. to make sure measure it with your volt meter. Hit the reset button to power on the ps2 or you wont get a reading. Remember your measuring DC not AC.

d_guth

10-14-2005, 11:25 PM

Sorry I took so long...thanks for reply...should have known fuse :)