Flying Scotsman
08-04-2005, 03:07 PM
I have now seen three posts with regard to Matrix Infinity ( blue dot) having problems with the firware upgrade where people are being presented with the screen which says "Programming please wait".
Having experienced this myself recently, I contacted Infinity Mods to see if they had any ideas as to what the problem may be as I had changed the chip for another on the same wires and it worked without problems.
I then tried the suspect chip with three different consoles and had no luck, it simply would not take the firmware.
Luke at infinity asked if I could try putting a little solder paste on the legs of the eeprom and go over them with the iron as he thought it might be a bad connection.
However I tried this but it still wouldn't work, so I sent it back for replacement.
It would be interesting to see if there are more of these problems, so would invite anyone having the same symptoms to post. :)
Having experienced this myself recently, I contacted Infinity Mods to see if they had any ideas as to what the problem may be as I had changed the chip for another on the same wires and it worked without problems.
I then tried the suspect chip with three different consoles and had no luck, it simply would not take the firmware.
Luke at infinity asked if I could try putting a little solder paste on the legs of the eeprom and go over them with the iron as he thought it might be a bad connection.
However I tried this but it still wouldn't work, so I sent it back for replacement.
It would be interesting to see if there are more of these problems, so would invite anyone having the same symptoms to post. :)