jdog006
07-07-2004, 06:45 PM
I know some of you are going to be opposed to this line of questions since this might delve into DNA$ territory. I will keep this as generic as possible. I don't think that it will necessarily be against the TOS.
I've been reading a lot lately about Disc ID Utils and such. I am trying to figure out if it can be done with a DMS3. You can't turn a DMS3 off after it has booted and this is the problem that I am running into when I'm going over this in my mind. The chip will need to be on in order to boot cd-r (ID Util) but it will need to be off to read valid ID from orig if I understand this correctly.
I was thinking that it might be possible to run the ID util from PC with pukklink and inlink but then I remembered that I would need the chip to boot the pukklink cd-r and that shot that idea down. I've thought about this from every angle that I am aware of and I don't think that it is possible unless a DMS firmware is released that would allow you to disable the chip AFTER bootup.
I purposely didn't go into details about what exactly would be accomplished by doing this or the details of how to do it. Although I'm sure that the majority (if not all) of you can read between the lines. Thanks.
I've been reading a lot lately about Disc ID Utils and such. I am trying to figure out if it can be done with a DMS3. You can't turn a DMS3 off after it has booted and this is the problem that I am running into when I'm going over this in my mind. The chip will need to be on in order to boot cd-r (ID Util) but it will need to be off to read valid ID from orig if I understand this correctly.
I was thinking that it might be possible to run the ID util from PC with pukklink and inlink but then I remembered that I would need the chip to boot the pukklink cd-r and that shot that idea down. I've thought about this from every angle that I am aware of and I don't think that it is possible unless a DMS firmware is released that would allow you to disable the chip AFTER bootup.
I purposely didn't go into details about what exactly would be accomplished by doing this or the details of how to do it. Although I'm sure that the majority (if not all) of you can read between the lines. Thanks.