- Broken Resistor value V14 (HELP)
- ps2 slim sudden disc read problem, please help
- If a PS2 wont turn on, whats the problem usually?
- v12 disk wan't spin
- v12 disk wan't spin
- removing warranty sticker v14 HOW TO
- V12 GH-035-11 burned too many lasers
- Swapping DVD-ROM Drives
- V14 3170SPU/PVR802w optical block switch.
- PS2 V10 Laser Rattling
- 400c lens help! v4 30001R
- Romeo fix
- I lifted the M point on a V13 off the mobo. HELP
- What temprature are u using while soldering on PS2?
- Matrix Infinity Diode
- Damaged Power Button
- Need HDD help
- unplugged bios battery - is this bad?
- PS2 to PC
- HD Connect soldering
- where to look next when all fuses ok??
- Guide to taking apart a V9 PS2 in need! Mod chip arriving tomorrow..
- playstation wont power on
- Configuring matrix
- Soldering question for dsm4 pro
- Laser problems?
- v12 I fix in place, should i remove before i apply summone??
- Copper VIA Pads Came Off---Help?
- v9: strange coil values
- need help very strange??????
- V12 infinity: Black screen
- SX point lifted off V12 board..what do i do?
- V10 Auto turn OFF + Reset led disco effect!
- Installing my first PS2 modchip - One Man's Journey
- DVD-ROM clicking sound.
- Black Screen Help!
- psTwo Slimeline Busted
- No lens activity on v9, suspect vias
- cd-tray is stuck!
- Ps2 apart problem
- PSTwo V12 won't start
- Slim PS2 Disassmebly Help
- V7 wont turn on
- How do you know when the dsm4 is working for the first time?
- ALT cd/dvd spots V3
- Headset (jack to USB)
- v12 dms lite, disc not spining
- v 14 power problem
- V4 Laser issues
- ps2 problems
- ps2 repair schp30001 voltage adjust?
- SCPH30003R - Laser dead?
- Noob V1 infinity install question
- V12 683 replace - wont read!
- v7 with new laser still not working
- v13 - Chip works, then i screw machine together..
- Fan Case
- Correct Way to Adjust Laser
- matrix infinity loading delay
- messiah 2 prob
- Refurbishing lasers
- help with ps2 laser
- Cable size?
- Optical Digital Out Faulty?
- crystal v1.1 install
- Ps2 v7 & network adapter problem (withHDD)
- Real time clock problem
- i think my laser ribbon cable touches the cd... how to stop this?
- ps2 dvd drive problem
- PS2 and HD + dead LA Chip
- PS-2 ver. 14 won't turn on with Matrix infinity chip
- Problem V4 Dvd-rom laser Problem
- gonna rage on this laser... need advice
- PS2 (non slimline) no sound
- Can lasers go "partially" bad?
- ps2 freezes when saving
- Replacing Laser PCB - worth it?
- Unmodded V10 reads original disks but won't authenticate
- Will a 5v Romeo mod put STRESS on the laser when reading official, pressed games?
- PS2 Fan doesnt work..
- is it dead????
- 2x V13 dead Laser after DMS4 installation
- Power Button Question
- V9 w/ fresh Matrix Infinity green dot install - no output
- 30awg
- Please help, my PS2 just crapped out (possible laser issue)
- fan connector broke on v3
- Did i just completely kill my lazer on my V9?
- Ps2 CD drive won't work
- v14 powers on no video, light green
- V5 ps2 will not read disk with new laser unless I kickstart it by finger
- PS2 Readerhead Cleaner
- Pstwo problem
- Opinions on this chip?
- V5 fan fuse
- take off v2 motherboard
- V9 Black Video No Audio
- Finally
- No Spin from my v13 slim.
- Bios,CD/DVD driver IC,oscillator & other IC locations
- ps2 v12 doesn't read discs
- V7 PS2 - Green LED not glowing
- V7 PS14 fuse blown??
- Where to buy PS2 fuses?
- Somebody please help!!!
- lenschanger help
- Weird disk read behavior, delayed disk read
- Swap magic 3.6 worked only two weeks, now I can't play DVDs
- Pnp key any good?
- ps2 subzero fix
- SCPH-50001 DRE help needed
- Net Yaroze hangs at the white boot screen
- PS2 cant read DVD's only
- colour fix doesn't make a diffrence on a v12 pal
- where do you download all your handy diagrams from??
- Question about laser diode
- Ghost 2 weird boot problem
- Neo Fix XIII on V14 question
- Playstation2 technical difficulties!
- F**ked Iron ... *sigh*
- V5 Disc tray won't eject
- Laser diodes
- PS2 Troubles? No red light! Nothing!
- Control pad
- PSTwo V12, the laser "engine" does not work....?
- Noisy PS2. problems with drive?!?!
- V4 and Lens KHS-400C what do I need to change it?
- 3.5 HDD power supply from psTWO slim v12
- V12 Silver, no output video/audio...?
- Analog Video (RGB) chip pinout- V0-V5
- v9 laser spinning like crazy
- Right Flux?
- Ba5815fm blows after short time
- Does the RS2004FS control the Video?
- Laser unit don't move since Sommone fix
- v4/5/6 to v9
- Soldering Iron Suggestions
- No power, V14, no lights...nothing!?
- frying the laser?
- New laser in LA
- sanyo and 400c lens cable
- ps2 v3 no video/audio
- How do I know my RS2004FS is dead?
- HD Connect questions.
- need help on repair replacement
- 12v point on v3?
- pot tweaking...
- PStwo V13 strange graphics
- Matrix Infinity 5E DNS.1011 on PAL V7 GH-022 39004, 22-pin Chip with Gap PCB
- Some problems reading copied DVD's with NEW KHS-400C laser
- v13 smd resistor ohm value?
- v10's come back to me going straight to browser
- v3 pal hard time reading dvd's
- Measuring the laser diode
- What degree would be compareable to 15-20 watts?
- Ps2 is skipping and slowing down...
- v12 silver , everytime i fit summ0nes it won't read??
- No vid/sound, no DVD activity.. Dead?
- very new to mod chips PLEASE PLEASE HELP
- Can't seem to solder this part of the MOBO! HELP!
- Very dumb fuse question
- holding chip on board
- [Help]Magic 2 and MVC2 problem ..
- Romero Mod, connect Pin17 to 7.5V instead of 5V?...
- DRE after v7 MI Green dot install
- PS2 Gone Crazy
- Laser Fix on V14 75004CB Slim PS-2...
- 'Fuzzy' sprites etc..
- V12 Rs2004Fs problem?
- help with multimeter
- Virgin Slim Jacked up Video
- Laser not reading cdr
- flux suggestions
- something wrong
- PS2 with Chipmod H20 Pro shuts off
- ghost 2 on a scph 10000
- V7 to V9 Power/Eject Cable pinout
- Swapping PS2 Slim drives
- Not booting to game...
- v7 dead drive?
- Desktop Magnifiers
- v9 Replacing the LA chip
- Controller port please help
- Safe method to check the laser diodes??
- Installing Matrix Infinity Green Dot
- Matrix infinity alternative solder points
- Vibration fuse on PS2 V3
- PS2 Problem please help.
- V3: DVDs Ok but CDs won't spin
- No display on tv and eject light won't come on
- No video/audio - black screen? No mod chip
- Should I take out Aladdin lens fix from my PS2 Slim?
- PS2 Drive Don't spin
- Replacing Fuses
- V4 Disk not spinning
- change of reading canyon
- Where to get new laser?
- CXM-4000 and CXM-4015 info help
- v12 BSOD and drive won't spin after installed DMS4 Lite
- v12 no reading on coils
- laser coil at 5.8~6 ohm and 4.2~4.5 ohms is it fried?
- help needed for building a repairguide for most common failures
- laser coiled burnt. Now what?
- Is LA6508=BA5810FP
- O2: flash hangs at 99% from MC (1.65)
- can someone help me with my hard drive formatting
- need help !! ps2 wont recognise memory cards
- is scph-75004 always v14?
- Subzero Fix Question
- H2O chip alternative BGHI for v14
- Testing the LA/BA chip for dud focus coils driver
- Reassembling a 400B laser
- Duo2 SE V7 Ps2 Install (Working but not reading my backups?)
- How did I blow 8 fuses...?!
- (V7 PAL) No vibration at all!
- Power Loss & More issues with V4 PS2 after modchip(DMS4SEPRO) install. Please Help.
- USB 1.1 to USB 2.0 ??? possible ???
- please help...
- Black Screen
- v9, unmodded black screen no laser spin??
- V9 brightness flickering
- Modding equipment for UKers?
- Microsoldering
- v12 no laser movement suggestions
- boot cd for matrix infinity green dot ?
- Disc read error help on SCPH-5001
- Broken tabs on motherboard & control port - rescue me!
- Strange TOC Error
- Fitting KHS400C Help
- Play backup's
- SubZero fix v12
- Need Repair Service
- Softwear help
- v9 with replaced 3rd party la6508
- v12 laser change
- lens scratched
- Credit Card Fix - Another Disc Read Error Solution??
- Can anyone help with these problems on Slimlines
- How to check a new laser in v12
- Strange
- Question abouth the "B" point on a v9 Mainboard
- V8 GH-022 Board Fuse help
- Help! Discs don't spin after laser replacement!
- Power Prob!!
- Help! Drive won't eject or spin
- Test V7
- I need a good ps2 solder iron
- V12 Disc Does Not Spinn !!!!
- solder tip needed
- Replacing DVD Drive